This extremely popular, professional grade yet easy to use, high quality Marble Polishing Compound is just what the doctor ordered for removing the majority of “water stains” (etching) and light scratches to restore the polish to most marble, travertine, alabaster (marble-onyx), onyx and polished limestone not by coating, but by abrasion and friction (like polishing a gemstone) as it was originally done in the factory.
Our concentrated neutral cleaner should be diluted with water 20/1 and used immediately after polishing with the Etch remover to neutralize the polish and clean up the slurry.

Fred Hueston, PhD, renowned stone and tile expert, prolific author on stone and tile matters, and Chief Technical Director at www.StoneandTilePROs.com says, "The single most frequent question we get at stoneandtilepros.com is 'How do I remove etching?' Well, kind of. More often than not, homeowners may not refer to it as 'etching' but will mistakenly call etch marks, 'water marks,' 'water rings,' or simply 'dull spots.' But the bottom line is what they're dealing with is etching caused from some acidic liquid (too often cleaning products that should never touch marble or travertine).

"My answer is always the same: if it's a minor etching on a polished marble, travertine, etc., that is it's not so rough you can feel it with your fingertips, or if it's not a very large area, use a good quality etch remover / marble polish to restore the finish yourself. Stonecare PRO Signature ETCH REMOVER and Marble Polish is simply the best etch remover and marble polish available on the market. If it does turn out that the etch is too severe and you do have to contact a PRO you haven't invested much and you can always keep it handy to polish out any minor etching that does occur. It's a great product to keep handy if you have polished marble."

Stonecare PRO Signature ETCH REMOVER Marble Polishing Compound Pro polishing kit is a special blend of polishing compounds formulated to remove etching from polished marble, travertine and limestone, combined with a bottle of our famous Neutral Cleaner.  Marble can be polished with ease without the use of special tools. Clean up is a snap with Stonecare pro Neutral Cleaner to finish the job.
Caution: Not for use with granite. Always test a spot first. For deep etches and scratches professional stone restoration may be needed.
Directions:
1. Wear rubber gloves and make sure not to get paste on adjacent surfaces.
2. Clean area to be polished with diluted StonecarePro Neutral Cleaner
3. Working one area at a time no bigger than one square foot, apply a small amount (about one teaspoon) of paste to dull area. Add water to keep area wet.
4. Use a white terry cloth or a white polishing pad and work the mixture in a circular motion.
5. Add water as neccessary to maintain a wet slurry. Remove slurry with a clean cloth and check to see if polish is restored. Repeat as neccessary.
TIP  Some stones may polish better by working the slurry until it is dry. If you have problems polishing try going wet to dry.
6. Once the shine is achieved rinse the area with water and dry with a clean cloth. Neutralize and finish with Neutral Cleaner for a better than new look!!!

KEEP OUT OF REACH OF CHILDREN. Avoid contact with eyes, bare skin and clothing. Wash thoroughly after handling.
FIRST AID: In case of contact, flush eyes immediately with plenty of water until irritation subsides. If irritation persists call a physician. Flush skin with tap water until clean. If swallowed do NOT induce vomiting. Drink plenty of water and call a physician. The product is not poisonous. Contains: Aluminum oxide, oxalic acid and other inert ingredients.